![]() This would work for the Integrex but may not be so lucky with the QT35 and its super old control. Have your boss look at MatrixCam from Mazak for software. ![]() If you're using the Mazatrol, you'll only see a small bit of G-code where you input for "G and M" on each unit operation or if you enter using "Manual Entry" key. Code is generated by a CAM system or can be handtyped. G-code = the codes used by the machine control to work the machine and build parts. there a few variations in use now but basically it's:ĬAD = Computer Aided Design(or drafting, or drawing) ex: Pro-E, Solidworks, etcĬAM = Computer Aided Machining (ex: MasterCam, Gibbs, SurfCam, etc) Software such as Griffo Brothers (CamLink) and Solutionware (MazaCam).Īs for the acronyms. There are a few platforms to help but none are necessarily "cheap" per se. ![]() I assume you're programming/operating using Mazatrol? (conversational programming). 60K for Mazak software? What software did they quote you? A whole simulator unit? I'd get that requoted.
0 Comments
Leave a Reply. |